DeVille V8-273 4.5L (1989)
Band: All Technical Service Bulletins
A/T - Revised Reverse Band Apply Pin Gauge
Bulletin No.
T-90-5
File in Group
977131 & 2
Number
7
Corp. Ref. No.
209
Date
Oct. 1989
SUBJECT:
NEW REVERSE BAND APPLY PIN, GAGE FOR THE THM 440-T4/4T60 TRANSAXLE AND REVERSE AND
1-2 BAND APPLY PIN GAGE FOR THE THM F-7 TRANSAXLE
MODELS AFFECTED:
1989-1990 DE VILLES, FLEETWOODS, ELDORADOS, SEVILLES, AND ALLANTES
A new reverse band apply pin gage, J-33382-10, will be available approximately October 15, 1989 to service all 1989 and 1990 THM 440-T4/4T60
transaxles. In addition, the gage can be used to select the reverse band pin and the 1-2 band apply (servo) pin on all 1989 and 1990 THM F-7 transaxles.
J-33382-10 has a hex head for easy identification.
IMPORTANT:
DO NOT USE PIN GAGE J-33382-10 ON 1988 OR PRIOR MODELS. CONTINUE TO USE J-33382-2 ON 1988 OR
EARLIER MODELS.
IMPORTANT:
Pin gage J-33382-2 may be used on 1989-1990 models until the new gage (J-33384-10 is available. When using J-33382-2 on
1989-1990 models, select the apply pin which is two sizes longer than indicated by the gage.
Service Manual Reference:
This product change information will be shown in the Automatic Transaxle Unit Repair Section of the 1990 Service Information Manual.
Service Tool Information:
The reverse band apply pin gage, J-33382-10, will be available approximately October 15, 1989 from Kent-Moore. It can be ordered through their order
department at (313) 574-2332 or 1-800-345-2233.