DeVille V8-300 4.9L (1993)
Step 5: Install Terminal(s)
Install terminal(s) into the connector body if previously removed in Step 2.
Step 6: Tape Diode to Harness
Tape the diode to the harness or connector using electrical tape. To prevent shorts to ground and water intrusion, completely cover all exposed
wire and diode attachment points.
Acceptable Diode Replacements
In the event 1 amp, 50 PIV (Peak Inverse Rating) diodes are unavailable, a universal diode with a 1 amp, 400 PIV rating can be used for the
following applications:
^
A/C Compressor Clutch
^
ABS/4WAL (the ABS Diode on the Delco Moraine is hidden inside of an electrical connector under the carpet at the RH panel)
^
Wiper
^
Charging System (hidden in wire harness)
^
Parking Brake (vehicle with ABS)
^
Relays
^
Solenoids
^
Diesel Glow Plug Circuit
Repairing Short Circuits Caused By Damaged Wire
SHORT CIRCUITS CAUSED BY DAMAGED WIRE INSULATION
^
Locate the damaged wire.
^
Find and correct the cause of the wire insulation damage.
^
For minor damage, tape over the wire. If damage is more extensive, replace the faulty segment of the wire.
Splicing Copper Wire Using Crimp and Seal Splice Sleeves
Crimp and seal splice sleeves may be used on all types of insulation except Tefzel and coaxial to form a one-to-one splice. They are to be used where
there are special requirements such as moisture sealing. Crimp and seal splice sleeves are included in the J 38125-A Terminal Repair Kit.
Step 1: Open the Harness
If the harness is taped, remove the tape. To avoid wire insulation damage, use a sewing "seam ripper" to cut open the harness (available from
sewing supply stores). The crimp and seal splice sleeves may be used on all types of insulation except Tefzel and coaxial and may only be used to
form a one-to-one splice.
Step 2: Cut the Wire
Begin by cutting as little wire off the harness as possible. You may need the extra length of wire later if you decide to cut more wire to change the
location of a splice. You may have to adjust splice locations to make certain that each splice is at least 40 mm (1.5 in.) away from other splices,
harness branches or connectors. This will help prevent moisture from bridging adjacent splices and causing damage.
