cadillac Workshop Repair Guides

Cadillac Workshop Service and Repair Manuals

Inside of Vehicle (Vehicle Scrapping Procedure)|Page 10409 > < Inside of Vehicle (Vehicle Scrapping Procedure)|Page 10407
Page 8
background image

Description

52. Route the deployment harness out of the passenger side of the vehicle.
53. Stretch the driver side harnesses to full length.
54. Stretch the passenger side harnesses to full length.
55. Completely cover the windshield and front door window openings with a drop cloth.
56. Place a power source, 12V minimum/2A minimum (i.e., a vehicle battery) near the shorted end of the harnesses.

Description

57. Separate the two ends of the inflatable restraint steering wheel module deployment harness wires.
58. Connect the inflatable restraint steering wheel module deployment harness wires to the power source in order to deploy the inflatable restraint

steering wheel module.

59. Disconnect the inflatable restraint steering wheel module deployment harness wires from the power source.
60. Separate the two ends of the LH inflatable restraint side impact inflator module deployment harness wires.
61. Connect the inflatable restraint side impact inflator module deployment harness wires to the power source in order to deploy the inflatable restraint

side impact inflator module.

62. Disconnect the inflatable restraint side impact inflator module deployment harness wires from the power source.

Description

63. Separate the two ends of the inflatable restraint IP module deployment harness wires.
64. Connect the inflatable restraint IP module deployment harness wires to the power source in order to deploy the inflatable restraint IP module.
65. Disconnect the inflatable restraint IP module deployment harness wires from the power source.
66. Separate the two ends of the RH inflatable restraint side impact inflator module deployment harness wires.
67. Connect the inflatable restraint side impact inflator module deployment harness wires to the power source in order to deploy the inflatable restraint

side impact inflator module.

68. Disconnect the inflatable restraint side impact inflator module deployment harness wires from the power source.

Description

69. Twist together one end of each wire on the driver side deployment harnesses in order to short the wires.

Description

Inside of Vehicle (Vehicle Scrapping Procedure)|Page 10409 > < Inside of Vehicle (Vehicle Scrapping Procedure)|Page 10407