DeVille V8-4.6L VIN Y (1998)
10. Remove the lower control arm outer nut and bolt.
11. Remove the upper control arm outer nut and bolt.
12. Disconnect the wheel speed sensor cable bracket from the knuckle.
13. Remove the knuckle.
INSTALLATION
1. Connect the wheel speed sensor cable bracket to the knuckle.
2. Position the knuckle in the upper control arm. Install the bolt and the nut.
3. Position the knuckle in the lower control arm. Install the bolt and the nut.
4. Install the new rear toe link outer bolt. Do not tighten the bolt at this time. The toe link must be tightened in design position in order to reduce
windup in the bushings.