DeVille V8-4.6L VIN Y (1998)
Stabilizer Link: Service and Repair
Front Suspension
REMOVAL
1. Raise and support the vehicle.
2. Remove the tire and wheel.
3. Remove the road sensing position sensor from the lower control arm.
4. Using a pair of needle nose pliers, hold the ball stud and remove the nut from the upper and lower attachment.
5. Remove the stabilizer link.
INSTALLATION
1. Install the stabilizer link.
2. Install the upper and lower stabilizer link nuts.
NOTICE: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners
requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion
inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage
the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
^
Tighten the nuts to: 55 Nm (41 ft. lbs.).
3. Install the road sensing position sensor.
4. Install the tire and wheel.
^
Tighten the wheel nuts to: 140 Nm (100 ft. lbs.).
5. Lower the vehicle.
