DeVille V8-4.9L VIN B (1995)
1. Position new fuel pipe in original location.
2. Remove protective caps from fuel pipe.
3. Apply a few drops of clean engine oil to the male connector pipe end.
4. Quick-connect fittings at and near fuel filter.
a. Push connector together to cause the retaining tabs/fingers to snap into place.
b. Once installed, pull on both ends of connection to make sure connection is secure.
5. Retaining hardware.
6. Lower vehicle.
7. Repeat connect procedure for engine compartment fuel pipe quick-connect fittings.
8. Tighten fuel filler cap.
9. Negative battery terminal.
^
Turn ignition switch to "ON" position for two seconds, then turn to "OFF" for five seconds. Again, turn to "ON" position and check for fuel
leaks.
FUEL PIPE-FUEL FILTER TO FUEL SENDER
Fuel Tank
