DeVille V8-4.9L VIN B (1995)
Distributor Disassembly, Test And Reassembly - Part 3 Of 3
REMOVE OR DISCONNECT
1. Ignition switch battery feed wire from distributor cap.
2. Ignition coil connectors from distributor cap.
3. Four (4) retainers on distributor cap and move cap out of way.
4. Six terminal PCM harness from distributor.
5. Distributor clamp nut and hold down clamp. Using J 29791 or equivalent.
6. Note position of rotor, then pull distributor up until rotor just stops turning counter clockwise and again note position of rotor.
7. Remove distributor.
