cadillac Workshop Repair Guides

Cadillac Workshop Service and Repair Manuals

Relays and Modules - Restraint Systems > < Restraints - Driver/Passenger Seat Head Rest Information
Page 1
background image

Knee Diverter: Service and Repair

WARNING: The diagnostic energy reserve module or sensing and diagnostic module (DERM/SDM) can maintain enough voltage to cause 
air bag deployment for up to two minutes after the ignition switch is turned off and the battery is disconnected. Servicing the SIR system
during this period may result in accidental deployment and personal injury.

1. Disarm system as described in Air Bag System Disarming & Arming.
2. Remove instrument panel lower trim panel.
3. Remove two twilight sentinel bracket retaining screws.
4. Remove two fuse block bracket retaining screws.
5. Remove two knee bolster tie bar retaining screws.
6. Remove left side instrument panel attaching screws.
7. Remove knee bolster attaching screws, then the knee bolster from instrument panel.
8. Reverse procedure to install, noting the following:

a. After completing installation, rearm system as described in Air Bag System Disarming & Arming.
b. Turn ignition switch to On position and verify that the Air Bag or SIR warning lamp flashes seven to nine times and then turns off. If lamp

does not respond as specified, refer to System Diagnosis.

Relays and Modules - Restraint Systems > < Restraints - Driver/Passenger Seat Head Rest Information