DeVille d Elegance V8-4.6L VIN Y (1998)
Electronic Brake Control Module: Service and Repair
REMOVAL PROCEDURE
IMPORTANT: The Electronic Brake and Traction Control Module (EBTCM) cannot be repaired. If faulty it must be replaced as an assembly.
1. Disconnect the negative battery cable. Refer to Service Precautions.
2. Remove the Air Cleaner Assembly.
3. Remove the three EBTCM/BPMV assembly bracket nuts.
4. Remove the EBTCM connector.
5. Remove the front insulator and insulator mounting bolt.
6. Remove the four EBTCM to Brake Pressure Modulator Valve (BPMV) bolts.
CAUTION: Do not pry the EBTCM from the BPMV as damage to the seal may result.
7. Separate the EBTCM from the BPMV by gently pulling forward until separated. Be careful not to damage the seal.
INSTALLATION PROCEDURE
IMPORTANT: When replacing the EBTCM, Magna Steers must be recalibrated. Refer to "Variable Effort Steering" in Steering.
1. Clean the seal and BPMV gasket surface with alcohol.
2. Install the EBTCM to the BPMV.
NOTICE: Refer to Service Precautions.