DeVille DHS V8-4.6L VIN Y (2000)
6. Remove the lead inside the clip on the side of the ignition and key alarm switch assembly.
7. Remove the connector (1) from the lock module assembly (4).
8. Remove the 2 tapping screws (3) from the ignition and key alarm switch assembly (2).
INSTALLATION PROCEDURE
NOTE: Refer to Fastener Notices in Service Precautions.
1. Install the ignition and key alarm switch assembly (2) and secure by using 2 tapping screws (3).
Tighten
Tighten the screws to 1.5 N.m (13 lb in).
2. Install the ignition and key alarm connector (1) onto the lock module assembly (4).
3. Install the green connector into the bottom of the ignition and key alarm switch assembly (2).
4. Put the lead in the clip located on the side of the ignition and key alarm switch assembly (2).
5. Install the control coded key (2) onto the lock module assembly (1).