DeVille DHS V8-4.6L VIN Y (2000)
9. Remove the pass through cable (1) from the seat back pass through.
10. Disconnect the heated seat and rear lumbar electrical connector, if equipped.
11. Position the rear shoulder belts in order to clear the rear seat back during removal.
12. Remove the rear seat back.
Installation Procedure
1. Install the rear seat back into the car.
2. Install the pass through cable (1) to the seat back pass through door.
3. Install the heated seat electrical and rear lumbar connectors, if equipped.
4. Position the rear shoulder belts over the seat back.
5. Align the four retainer clips on the seat back with the slots on the cross car beam.
6. Push on the seat back firmly, at the top, in order to engage the upper seat back clips.
7. Position the center shoulder belt over the seat back.
Notice: Refer to Fastener Notice in Cautions and Notices.
Important: