DeVille DHS V8-4.6L VIN Y (2000)
Wheel Speed Sensor: Service and Repair
Wheel Speed Sensor Replacement Rear (W/FE7)
Removal Procedure
^
Tools Required
-
J 39200 Digital Multimeter
-
J 44252 ABS Sensor Installer
1. Turn OFF the ignition.
2. Raise the vehicle. Refer to Vehicle Lifting.
3. Remove the rear wheel. Refer to Tire and Wheel Removal and Installation in Wheels, Tires and Alignment.
4. Remove the wheel speed sensor connector (1) from the wheel speed sensor (2).
Important: Do not reuse the wheel speed sensor after it has been removed.
5. Remove and discard the wheel speed sensor (2).
Installation Procedure
Important: The connector of the wheel speed sensor must point toward the brake caliper.
1. Insert the wheel speed sensor (1) onto the hub assembly.
2. Install the ring (2) of the J 44252 ABS sensor installer onto the wheel speed sensor.