DeVille DHS V8-4.6L VIN Y (2000)
11. Position the generator coolant pipe/surge tank pipe (2) on to the fuel rail studs.
12. Position the engine coolant heater wire (1) on to the fuel rail studs (if equipped).
13. Install the two pushnuts.
14. Install the fuel rail bracket retaining nut (1) to the rear lift bracket.
Tighten the fuel rail bracket retaining nut (1) to 4 Nm (35 inch lbs.).
15. Install the quick connect fittings to the fuel rail.
16. Connect the vacuum tubes (2) to the AIR solenoid.
17. Connect the fuel regulator vacuum tube (1).