DeVille DHS V8-4.6L VIN Y (2000)
3. Route the accelerator control cable (2) over the brake master cylinder and through the dash.
4. Secure the accelerator control cable (2) at the retainer (1) on the dash (bulkhead).
5. Install the accelerator control cable (1) at accelerator controls pedal (3).
IMPORTANT: Check for complete throttle opening and closing positions by operating accelerator controls pedal. Also check for poor carpet fit
under the accelerator controls pedal. Throttle should operate freely without bind between full closed and wide open throttle.
6. Remove the left closeout insulator panel.
