cadillac Workshop Repair Guides

Cadillac Workshop Service and Repair Manuals

General Information|Page 11152 > < General Information|Page 11150
Page 2
background image

malfunctions.

EEPROM (ELECTRICALLY ERASABLE PROGRAMMABLE READ ONLY MEMORY)

Memory that does not require power to the inflatable restraint Sensing and Diagnostic Module (SDM) in order to retain its contents.

HIGHER PRIORITY FAULT

Each DTC has an assigned priority based on its detectability with other DTCs present. The priority corresponds to the detectability of the malfunction
only. This does not relate to the seriousness of the malfunction with respect to deployment or non deployment under any given condition.

IGNITION CYCLE

The operation of the ignition switch causes this cycle to occur. The inflatable restraint Sensing and Diagnostic Module (SDM) must first sense
IGNITION 1 input greater than 9.0 V with the ignition switch in RUN. The IGNITION 1 input voltage must remain above 9.0 V for at least 10 seconds
before turning the ignition switch to OFF.

INFLATABLE RESTRAINT SENSING AND DIAGNOSTIC MODULE (SDM)

The SIR control module that provides reserve energy to the deployment loops, deploys the air bags when required, and performs diagnostic monitoring
of all SIR system components.

INFLATABLE RESTRAINT IP MODULE

An assembly located on the IP consisting of an inflatable air bag, an inflator, and an initiator.

INFLATABLE RESTRAINT STEERING WHEEL MODULE

An assembly located in the steering wheel hub consisting of an inflatable bag, an inflator, and an initiator.

INFLATABLE RESTRAINT STEERING WHEEL MODULE COIL

An assembly of two or more current carrying coils mounted within the steering column hub. The assembly allows the rotation of the steering wheel while
maintaining continuous electrical circuit contact. Two of the coils provide continuous contact of the driver deployment loop to the inflatable restraint
steering wheel module.

INFLATABLE RESTRAINT SIDE IMPACT SENSOR (SIS)

The SIS is a discriminating sensor use as an input to the SDM to monitor the vehicle side accelerations/ decelerations to determine in a crash event which
requires side airbag protection is needed. The SDM module provides reserve energy to the deployment loops, deploys the air bags when required.

INFLATABLE RESTRAINT SIDE IMPACT INFLATOR MODULES

An assembly located on the outboard sides of the front seat backs consisting of an air bag, an inflator and an initiator.

INFLATABLE RESTRAINT REAR SIDE IMPACT INFLATOR MODULES (W/AW9 OPTION)

An assembly located behind rear seat back consisting of an air bag, an inflator and an initiator.

INITIATOR

Located in the inflator module, the initiator initiates the chemical reaction that inflates the air bag when sufficient current flows through the component.

NORMAL OPERATING VOLTAGE RANGE
9.0-16.0 V
 when measuring between the inflatable restraint Sensing and Diagnostic Module (SDM) IGNITION POSITIVE VOLTAGE terminal and
ground.

POWER-ON TESTS

Tests that the inflatable restraint Sensing and Diagnostic Module (SDM) performs on the SIR system once per ignition cycle. These tests occur
immediately after the module receives IGNITION 1 voltage, and before the continuous monitoring tests.

SCAN TOOL

An off-board computer that reads on-board computer diagnostic information through the use of a DLC.

General Information|Page 11152 > < General Information|Page 11150