DeVille DHS V8-4.6L VIN Y (2000)
Front Steering Knuckle: Service and Repair
RPO FE1, FE3
Removal Procedure
-
Tools Required
-
J43828 Ball Joint Separator
-
J24319-B Steering Linkage and Tie Rod Puller
-
J28733-B Hub and Bearing Puller
1. Raise the vehicle. Refer to Vehicle Lifting.
2. Remove the wheel and tire. Refer to Tire and Wheel Removal and Installation in Wheels, Tires and Alignment.
3. Remove the wheel drive shaft nut.
4. Remove the lower ball joint cotter pin (1) and nut (2).
5. Remove the brake caliper bolts. Refer to Brake Caliper Replacement - Front (Without J55) or Brake Caliper Replacement - Front (J55) in Disc
Brakes.
6. Support and hang the caliper away from the brake rotor.
7. Remove the rotor. Refer to Brake Rotor Replacement - Front (Without J55) or Brake Rotor Replacement - Front (J55) in Disc Brakes.
8. Disconnect the wheel speed sensor connector.