DeVille DHS V8-4.6L VIN Y (2000)
25. Shake the glass primer (black #2) for at least one minute.
26. Use a new dauber in order to apply the glass primer (black #2) to the same areas (2) that the glass prep (clear #1) was applied.
The glass primer (black #2) is good up to 8 hours after applying it to the glass (1). The primed surface of the glass must be kept clean.
27. Allow the glass primer to dry for approximately 10 minutes.
28. Cut the tip of the applicator nozzle as follows:
1. If using the short method, cut the tip of the applicator nozzle in order to provide a bead of 6.0 mm (1/4 in).
2. If using the extended method, cut the tip of applicator nozzle in order to provide a bead of 12.7 mm (1/2 in) wide and 12.7 mm (1/2 in) high.
29. Use a cartridge type caulking gun to apply a smooth, continuous bead of urethane adhesive.
30. When using the short method, apply the urethane adhesive to the existing bead of urethane adhesive to the body.
31. When using the extended method, use the edge of the windshield, or the inside edge of the reveal molding as a guide for the nozzle in order to
apply the urethane adhesive (1) to the inner surface of the windshield (3).
If applying urethane adhesive to the inside edge of the windshield reveal molding (2), use the windshield reveal molding as a guide for the nozzle.