DeVille DHS V8-4.6L VIN Y (2000)
3.
Apply 5 cm (2 in) wide masking tape overlapping the 19 mm (3/4 in) wide masking tape in order to protect the painted surface of the roof panel
(2).
Important:
Use extreme care to ensure that the adhesive does not come in contact with any painted portions of the vehicle.
4.
Use a plastic trim stick to hold back the upper windshield reveal molding (1) and apply a smooth, continuous bead of the urethane adhesive (5)
between the underside of the windshield reveal molding and the roof panel edge (4) from the center of the upper windshield to one side of the
vehicle. Use the Urethane Adhesive Caulking Kit, U.S. P/N 12346392, Canadian P/N 10952983, or the equivalent* such as Speed Set(TM)
Windshield Sealant from Kent Industries, P/N 10545.
* Refer to Corporate Service Bulletin Number 83-15-16 for additional information on urethane adhesives equivalent to P/N 12346392.
5.
Repeat Step 4 on the opposite side of the vehicle.
6.
After applying the adhesive, ensure the molding is laying flat with no wrinkles.
Important:
Do not physically disturb the repair area until after the minimum time has elapsed. Allow a minimum of 1 hour for the chemical-curing type urethane
adhesive.
7.
Carefully remove the protective masking tape from the painted surface of the roof panel.
8.
Clean any excess urethane adhesive from the body.
Parts Information
Parts are currently available from GMSPO.
Warranty Information
For vehicles repaired under warranty, use the table.
DISCLAIMER
