DeVille DTS V8-4.6L VIN 9 (2002)
5. Loosen the center bolt of the J 42842 until the center hub protrudes approximately one-half inch beyond the outer plate. It is not necessary to
completely unthread the center bolt and separate the two pieces of the J 42842.
6. Place the J 42842 on to the crankshaft.
7. Thread the 3 mounting bolts into the crankshaft flange.
8. Tighten the bolts until the J 42842 is firmly mounted on the crankshaft.
9. Install the crankshaft rear oil seal by tightening the center bolt until the J 42842 bottoms against the crankcase.
10. Loosen the center bolt to release pressure on the crankcase.
11. Loosen the 3 mounting bolts.
12. Remove the J 42842 from the crankshaft flange.
13. Inspect to ensure the installation depth is equal around the crankshaft rear oil seal's circumference. If the depth is not equal reinstall the J 42842
and repeat the installation procedures.
14. Install the flywheel.