DeVille DTS V8-4.6L VIN 9 (2002)
2. Remove the tire and wheel.
3. Insert a large, flat bladed tool (1) into the caliper and rotor to prevent the rotor from turning.
4. Remove the wheel drive shaft nut.
5. Remove the brake rotor.
6. Disconnect the front wheel speed sensor connector and unclip from the dust shield.
7. Remove the wheel bearing and hub retaining bolts
8. Using J 28733-B separate hub and bearing from the drive axle.
9. Remove the wheel bearing and hub.
Installation Procedure
Important:
^
Clean rust and foreign material from the knuckle mounting face, bore and chamfer to allow for proper seating of the bearing and knuckle.
^
Do not handle the wheel bearing and hub by the ABS sensor wire.