DeVille DTS V8-4.6L VIN 9 (2002)
Door/Rear Door Panel/Service and Repair
Window/Division Channel - Rear Door Stationary
Window/Division Channel - Rear Door Stationary
Removal Procedure
1. Remove the water deflector. Refer to Water Deflector Replacement - Rear Door (See: Body and Frame/Doors, Hood and Trunk/Doors/Rear
Door/Rear Door Panel/Service and Repair) .
2. Remove the inner window belt sealing strip. Refer to Sealing Strip Replacement - Rear Door Window Belt Inner (See: ) .
3. Remove the window. Refer to Window Replacement - Rear Door (See: Service and Repair) .
4. Remove the two push pins (2) on either sides of the assembly (1).
5. Remove the rear window channel lower retaining fastener (1).
6. Grasp the front, lower end of the window run channel at the center pillar and pull out along the length of the header, stopping at the division post.
7. Grasp the top of the division post and pull forward, unseating it from the reveal molding.
8. Remove the assembly from the door in an upwards motion.
Installation Procedure
1. Insert the division post into the door opening.
2. Push the assembly down until the upper assembly is past the flange, this will ensure that the outer sealing strip will be properly positioned.
3. Pull the assembly upward into the door flange, making sure the division post retaining bolt is aligned with the slot and the locator aligns with the
notch in the door flange.
4. Seat the run channel along the door flange.
5. Press in the two push pins (2).
Notice: Refer to Fastener Notice in Cautions and Notices.
6. Install the rear window channel lower retaining fastener.
Tighten the fastener to 9 N.m (80 lb in).
7. Install the window. Refer to Window Replacement - Rear Door (See: Service and Repair) .
8. Install the inner window belt sealing strip. Refer to Sealing Strip Replacement - Rear Door Window Belt Inner (See: ) .
9. Install the water deflector. Refer to Water Deflector Replacement - Rear Door (See: Body and Frame/Doors, Hood and Trunk/Doors/Rear
Door/Rear Door Panel/Service and Repair) .
