DeVille DTS V8-4.6L VIN 9 (2002)
Rear Door Window Regulator: Service and Repair
Window Regulator Replacement - Rear Door
Removal Procedure
1. Remove the door trim panel. Refer to Trim Panel Replacement - Side Rear Door See: Body and Frame/Doors, Hood and Trunk/Doors/Rear
Door/Rear Door Panel/Service and Repair.
2. Remove the door module. Refer to Door Control Module Replacement.
3. Remove the water deflector. Refer to Water Deflector Replacement - Rear Door (See: Body and Frame/Doors, Hood and Trunk/Doors/Rear
Door/Rear Door Panel/Service and Repair) .
4. Remove the inside handle assembly (1) in order to gain access to the window clamp attachment bolts:
1. Carefully pry the front of the assembly (1) rearward.
2. Pull the front of the assembly (1) outward.
3. Slide the assembly (1) forward to remove.
5. Disconnect the handle rod from the clip guide (2).
Caution: Refer to Express Window Down Caution in Cautions and Notices.
6. Reconnect the power window switch and module.
7. Raise the window to the full up position.
8. Tape the window in place.
Caution: Refer to Glass and Sheet Metal Handling Caution in Cautions and Notices.
9. Loosen the window clamp attachment fasteners.
10. Lower the regulator clamps (2) to the full down position.
11. Disconnect the electrical connector from the window regulator motor.
12. Remove the window regulator to inner door panel fasteners (2).