DTS V8-4.6L VIN Y (2006)
6. Disconnect the CKP sensor wiring harness electrical connector (3) from the right knock sensor.
7. Remove the harness clip (4) from the engine block hole.
8. Remove the CKP sensor wiring harness bolts (1, 2).
9. Remove the CKP sensor wiring harness.
INSTALLATION PROCEDURE
1. Install the CKP sensor wiring harness.
2. Install the CKP sensor wiring harness bolts (1, 2).
-
Tighten the bolt (1) to 10 N.m (89 lb in).
-
Tighten the bolt (2) to 20 N.m (15 lb ft).
NOTE: Refer to Fastener Notice in Service Precautions.
3. Install the harness clip (4) to the engine block hole.
4. Connect the CKP sensor wiring harness electrical connector (3) to the right knock sensor.