DTS V8-4.6L VIN Y (2006)
Place a pipe wrench on the rack (5) next to the inner tie rod housing (6).
6. Place a wrench on the flats of the inner tie rod housing (6).
7. Rotate the inner tie rod housing (6) counterclockwise, while holding the rack stationary, until the inner tie rod separates from the rack (5).
8. Notice: Do not change the steering gear preload adjustment before moving the inner tie rod from the steering gear. Changing the steering gear
preload adjustment before moving the inner tie rod could result in damage to the pinion and the steering gear.
Remove the shock dampener (3) from the inner tie rod housing (2).
9. Slide the shock dampener (3) back on the rack (5).
10. Notice: Refer to Pipe Wrench Positioning Notice in Service Precautions.
Place a pipe wrench on the rack.
11. Place a wrench on the flats of the inner tie rod housing (2).
12. Rotate the inner tie rod housing (2) counterclockwise, while holding the rack stationary, until the inner tie rod (1) separates from the rack (5).
13. If female rack (1) and male inner tie rod (3), remove the old LOCTITE from the threads (2) of the inner tie rod and the rack. If male rack (5) and
female inner tie rod (4) LOCTITE will not be present.
Assembly Procedure
1. Slide the shock dampener (4) forward onto the rack (3).
2. Important: Threads must be clean prior to LOCTITE application. Check LOCTITE or equivalent container for expiration date. Use only enough
LOCTITE to evenly coat threads.
If male rack (3) and female inner tie rod (2) do not apply LOCTITE.