DTS V8-4.6L VIN Y (2006)
13. Insert a 0.25 mm gage (1) between the rack (2) and the inner tie rod housing in order to check both stakes. The feeler gage (1) must not pass
between the rack and the housing stake.
14. Slide the shock dampener (2) over the inner tie rod housing (3) until the front lip of the shock dampener (2) bottoms against the inner tie rod
housing (3).
15. To assemble the rack and pinion boot.
Rack and Pinion Outer Tie Rod End Replacement
Rack and Pinion Outer Tie Rod End Replacement
Removal Procedure
^
Tools Required
^
J 24319-B Steering Linkage and Tie Rod Puller
1. Raise and support the vehicle. Refer to Vehicle Lifting.
2. Remove the tire and wheel.