Eldorado V8-4.6L VIN Y (1994)
The following procedure and parts have been developed to correct the jamming condition (see illustration).
Important:
Before beginning this procedure, refer to bulletin # 219004 (Cadillac: T-92-73, GM of Canada: 93-9-117). If repairs are unsatisfactory after
performing that bulletin, then proceed with the following.
1.
Remove trunk front trim panel. Refer to Section 9K of the Service Manual.
2.
Remove RKE module from trunk panel. Module located on upper left side of panel.
3.
Assemble new RKE module, automatic door lock module and harness.
4.
Install module onto trunk panel.
5.
Using outboard hole from old module location, install screw at harness end of module, slide opposite end under Universal Theft Deterrent module,
no screw needed. Module should be parallel with trunk panel top section when installed properly.
6.
Remove protective plastic from hook and loop material on wiring harness and adhere to RKE module surface.
7.
Clip Automatic Door Lock module to left upper metal edge of rear seat pass through surface.
8.
Install trunk trim panel.
9.
Program transmitters. Use procedure in Section 9K, transmitter buttons only need to be pressed once to program for the TRW system, all other
steps are the same.
Important:
