Escalade ESV RWD V8-6.2L (2010)
1. Position the engine mount bracket onto the frame.
2. Perform the following steps prior to installing the engine mount bracket bolts.
*
Remove all traces of the original adhesive patch.
*
Clean the threads of the bolt with denatured alcohol or equivalent and allow to dry.
*
Apply threadlock GM P/N 12345382 (Canadian P/N 10953489) or equivalent to the bolts.
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
3. Install the engine mount bracket bolts.
Tighten the bolts to 65 Nm (48 lb ft).
4. Install the engine mount. Refer to Engine Mount Replacement - Left Side (1500 w/RPO LY2) (See: Engine Mount Replacement - Left Side
(1500 w/RPO LY2))Engine Mount Replacement - Left Side (1500 except RPOs LY2 and LY6) (See: Engine Mount Replacement - Left Side
(1500 except RPOs LY2 and LY6))Engine Mount Replacement - Left Side (2500 w/RPO LY6) (See: Engine Mount Replacement - Left Side
(2500 w/RPO LY6)).
Engine Mount Replacement - Left Side (1500 w/RPO LY2)
Engine Mount Replacement - Left Side (1500 w/RPO LY2)
Removal Procedure
Caution: When raising or supporting the engine for any reason, do not use a jack under the oil pan, any sheet metal, or the crankshaft pulley. Due to the
small clearance between the oil pan and the oil pump screen, jacking against the oil pan may cause the pan to be bent against the pump screen. This will
result in a damaged oil pickup unit.