Escalade ESV RWD V8-6.2L (2010)
13. Install the oil pan-to-front cover bolts (1) until snug. Do not over tighten.
14. Install J 41476 to the front cover.
15. Align the tapered legs of the J 41476 with the machined alignment surfaces on the front cover.
16. Install the crankshaft balancer bolt until snug. Do not overtighten.
1. Tighten the oil pan to front cover bolts to 25 Nm (18 lb ft).
2. Tighten the engine front cover bolts to 25 Nm (18 lb ft).
17. Remove the J 41476.
18. Connect the engine harness electrical connector (1) to the CMP sensor wire harness electrical connector.
19. Install a NEW crankshaft front oil seal. Refer to Crankshaft Front Oil Seal Replacement (With LY6) (See: Seals and Gaskets/Front Crankshaft
Seal/Service and Repair).
20. Install the water pump. Refer to Water Pump Replacement (See: Water Pump/Service and Repair).
