Escalade ESV RWD V8-6.2L (2010)
3. Install the generator battery jumper cable terminal (1) to the generator stud.
4. Install the battery jumper cable nut (2) to the generator.
Tighten the cable nut to 9 Nm (80 lb in).
5. Position the battery jumper cable boot (3).
6. Connect the engine harness electrical connector (3) to the generator.
7. Install the accessory drive belt. Refer to Drive Belt Replacement - Accessory (See: Engine, Cooling and Exhaust/Engine/Drive Belts, Mounts,
Brackets and Accessories/Drive Belt/Service and Repair/Drive Belt Replacement - Accessory).
8. Install the intake manifold sight shield. Refer to Upper Intake Manifold Sight Shield Replacement (See: Engine, Cooling and
Exhaust/Engine/Intake Manifold/Service and Repair/Upper Intake Manifold Sight Shield Replacement).
9. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection (See: Battery/Battery Cable/Negative/Service
and Repair/Battery Negative Cable Disconnection and Connection).