Escalade ESV RWD V8-6.2L (2010)
Suspension Travel Bumper: Service and Repair
Front Suspension
Jounce Bumper Replacement (2500 Series)
Removal Procedure
Note: The following service procedure is for 2500 series vehicles.
1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle (See: Wheels and Tires/Vehicle Lifting/Service and Repair).
2. Remove the tire and wheel. Refer to Tire and Wheel Removal and Installation (See: Wheels and Tires/Service and Repair).
3. Remove the nut from the jounce bumper stud.
4. Remove the jounce bumper.
Installation Procedure
1. Install the jounce bumper.
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
2. Install the nut to the jounce bumper stud and tighten to 30 Nm (22 lb ft).
3. Install the tire and wheel. Refer to Tire and Wheel Removal and Installation (See: Wheels and Tires/Service and Repair).
4. Lower the vehicle.