Escalade ESV RWD V8-6.2L (2010)
1. Position the wheel stud in the rear axle shaft.
2. Using washers and a wheel nut, tighten the wheel nut until the wheel stud is firmly seated in the rear axle shaft.
3. Remove the wheel nut and the washers.
4. Install the rear axle hub assembly, if removed. Refer to Rear Axle Hub, Bearing, Cup, and/or Seal Replacement (See: Transmission and
Drivetrain/Drive Axles, Bearings and Joints/Axle Bearing/Service and Repair/Rear Axle Hub, Bearing, Cup, and/or Seal Replacement).
5. Install the brake rotor. Refer to Rear Brake Rotor Replacement (1500 Series) (See: Brakes and Traction Control/Disc Brake System/Brake
Rotor/Disc/Service and Repair/Removal and Replacement/Rear Brake Rotor Replacement (1500 Series))Rear Brake Rotor Replacement (2500
Series) (See: Brakes and Traction Control/Disc Brake System/Brake Rotor/Disc/Service and Repair/Removal and Replacement/Rear Brake Rotor
Replacement (2500 Series)).
6. Install the tire and wheel. Refer to Tire and Wheel Removal and Installation (See: Service and Repair).
7. Remove the supports and lower the vehicle.
