Escalade ESV RWD V8-6.2L (2010)
7. Position the J-9522-5 - U-Joint Bearing Spacer Remover (1) on the universal joint.
Note: The following procedure is also used for the breaking of the nylon injected ring for those universal joints that are equipped.
8. Using the J-9522-3 - Separator, J-9522-5 - Remover and a press, remove the universal bearing from the yoke.
9. Rotate the propeller shaft and repeat steps 1-8 to remove the opposite universal joint.
Note: If the slip yoke is found to be damaged, replace the slip yoke and use a NEW universal joint. DO NOT re-use the old universal joint.
10. Remove the slip yoke (1) from the propeller shaft (2).