Escalade V8-5.7L VIN R (2000)
Drink Holders: Procedures
Cupholder Replacement
REMOVAL PROCEDURE
1. Remove the ashtray.
2. Slide the cupholder out.
3. Remove the knee bolster.
4. Remove the cupholder retainer from underneath the instrument panel by twisting the retainer to the left.
5. Remove the cupholder.
INSTALLATION PROCEDURE
1. Slide the cupholder onto the metal track in the instrument panel.
2. Install the cupholder retainer from underneath the instrument panel by twisting the retainer to the right.
3. Slide the cupholder into the instrument panel.
NOTE: Refer to Fastener Notice in Service Precautions.
4. Install the two rear screws to the cupholder
Tighten
Tighten the screws to 2 N.m (18 lb in), while holding the cupholder face plate against the cluster bezel opening to assure proper alignment.
5. Install the ashtray.
6. Install the knee bolster.
Cupholder Replacement - Front Floor Console
REMOVAL PROCEDURE
1. Open the cup holder by pulling down from the rear of the floor console.