Escalade V8-5.7L VIN R (2000)
5. Fill both housing cavities between the bushings with GM P/N 18010909 or the equivalent.
Notice: Refer to Fastener Notice in Service Precautions.
6. Install the mounting bolt and the sleeve assemblies.
^
Tighten the bolt to 51 Nm (38 ft. lbs.). The bolts boots must remain secure after tightening the bolts.
7. Connect the brake hose to the caliper.
^
Tighten the brake hose bolt to 45 Nm (33 ft. lbs.).
8. Measure the clearance between the caliper and the bracket stops.
^
If necessary, remove the caliper and file the ends of the bracket to obtain a 0.26 to 0.60 mm (0.010 to 0.024 inch) total clearance.
^
Measure the clearances individually and then add them together.
Important: Pump the brake pedal until it is firm before moving the vehicle. Check the fluid level in the master cylinder after pumping the brakes.
^
Install the tire and the wheel.
Bendix Brakes
Removal Procedure