Escalade V8-5.7L VIN R (2000)
1. Shake the pinchweld primer (black #3) for at least one minute.
2. Use a new dauber to apply the pinchweld primed (black #3) to the surface of the bonding area.
3. Allow the primer to dry for approximately 10 minutes, also check to ensure that all nicks and scratches are covered.
4. With the aid of an assistant, dry fit the stationary window into the opening.
5. Install the reveal molding to the edge of the stationary window. If the original reveal molding is damaged it must be replaced.
6. Use masking tape in order to mark the location of the stationary window in the opening.
7. Slit the masking tape at the top edge of the stationary window.
8. Remove the stationary window from the opening.
9. Place the stationary window inside up on a clean, protected surface.
10. If using the original window, remove all but approximately 2 mm (3/64 in.) the existing urethane adhesive from the window surface by using a
clean utility knife or razor blade scraper.
11. Clean the inside surface of the stationary window with GM Glass Cleaner P/N 1050427 or equivalent.
12. If the extended method is being used remove all but approximately 2 mm (3/64 in) of the existing bead of adhesive from the pinchweld flange.
Important: Do not remove all traces of the adhesive. Remove all mounds or loose pieces of urethane adhesive.
13. Shake the pinchweld primer (black #3) for at least one minute.
14. Use a new dauber to apply the primer to the surface of the pinchweld flange.
15. Allow the glass primer to dry for approximately 10 minutes.
Important: Use the following procedure:
16. Use care when applying the stationary window prep (clear #1) in order to prevent the stationary window preparation from running into the vision
area of the stationary window. This primer dries almost instantly and may stain the viewing area of the stationary window.