Escalade V8-6.0L VIN N (2002)
Shock Absorber Replacement (15 Series Utility)
Shock Absorber Replacement (15 Series Utility)
Removal Procedure
1. Raise and support the vehicle. Refer to Vehicle Lifting.
2. Disconnect the electrical connector and air line if equipped with Real Time Damping (RTD).
3. Support the rear axle.
4. Disconnect the RTD sensor (if equipped).
5. Remove the upper shock absorber nut and the bolt.
6. Remove the lower shock absorber nut and the bolt.
7. Remove the shock absorber.
Installation Procedure
1. Install the shock absorber.
Notice: Refer to Fastener Notice in Service Precautions.