Escalade 4WD V8-6.0L Hybrid (2011)
4. Install the coolant air bleed covers (313) and seals (308), if required.
5. If required, install the coolant air bleed cover bolts (312) 12 Nm (106 lb in).
6. Install the radiator vent inlet hose (2) to the coolant air bleed pipe fitting.
7. Position the radiator vent inlet hose clamp (1) at the coolant air bleed pipe fitting.
8. Install the air cleaner outlet duct. Refer to Air Cleaner Resonator Outlet Duct Replacement See: Engine/Tune-up and Engine Performance
Checks/Air Cleaner Housing/Air Cleaner Fresh Air Duct/Hose/Service and Repair.
9. Fill the cooling system. Refer to Cooling System Draining and Filling See: Service and Repair/Cooling System Draining and Filling.
10. If the rear coolant air bleed covers were replaced, install the intake manifold. Refer to Intake Manifold Replacement See: Engine/Intake
Manifold/Service and Repair/Intake Manifold Replacement.