Escalade 4WD V8-6.0L Hybrid (2011)
1. Install the a NEW CMP actuator solenoid valve until snug.
With the CMP actuator properly positioned onto the camshaft, the CMP actuator solenoid valve can be threaded completely into the camshaft
using light hand pressure. Tighten by hand until snug.
Caution: Refer to Fastener Caution See: Service Precautions/Vehicle Damage Warnings/Fastener Caution.
2. Tighten the CMP actuator solenoid valve.
1. Tighten the solenoid valve a first pass to 65 Nm (48 lb ft).
2. Tighten the solenoid valve a final pass and additional 90 degrees using J 45059 .
3. Install the CMP actuator magnet. Refer to Camshaft Position Actuator Magnet Replacement See: Camshaft Position Actuator Magnet
Replacement.
