Escalade 4WD V8-6.0L Hybrid (2011)
2. Install the outer bearing into the wheel hub.
Note: Drive the outer bearing cup into the wheel hub until it is just past the retaining ring groove. Do not bottom out the bearing assembly in the
bore.
3. Using the J 44419 - installer (2) and the J 8092 - handle (1), install the outer bearing cup into the wheel hub.
Note: Ensure that the retaining ring is fully and evenly seated in the groove.
4. Install the retaining ring into the groove.
Note: Ensure that the outer bearing assembly rotates freely in the hub
5. Using the J 24426 - installer (2) and the J 8092 - handle (1), turn the wheel hub over and seat the outer bearing assembly against the retaining
ring.