Escalade AWD V8-6.0L Hybrid (2010)
1. Ignition OFF, disconnect the harness connector at the Heated/Cooled cup holder.
2. Test for less than 10 ohms between the ground circuit terminal A and ground.
‹› If greater than the specified range, test the ground circuit for an open/high resistance.
3. 2. Ignition ON, verify that a test lamp illuminates between the B+ circuit terminal D and ground.
‹› If the test lamp does not illuminate, test the B+ circuit for a short to ground or an open/high resistance. If the circuit tests normal and the B+
circuit fuse is open, test or replace the Heated/Cooled cup holder.
4. If all circuits test normal, test or replace the Heated/Cooled cup holder.
Repair Instructions
Perform the Diagnostic Repair Verification (See: Powertrain Management/Computers and Control Systems/Testing and Inspection/Diagnostic Trouble
Code Tests and Associated Procedures/Verification Tests and Procedures) after completing the diagnostic procedure.
Floor Console Bezel Replacement (Cadillac) (See: Console/Service and Repair/Floor Console Bezel Replacement (Cadillac))Floor Console Bezel
Replacement (Except Cadillac) (See: Console/Service and Repair/Floor Console Bezel Replacement (Except Cadillac))
