Escalade AWD V8-6.0L Hybrid (2010)
17. Position the engine wiring harness (electronic throttle control branch) as necessary.
18. Install the engine wiring harness (electronic throttle control branch) clip to the ignition coil bracket stud.
19. Connect the engine harness electrical connector (1) to the ignition coil wire harness.
20. Install the CPA retainer (2).
21. Position the generator control module 3 phase cables to the bracket channel.
22. Install the generator control module 3 phase cable clip to the tab (3) on the engine bracket (2).
23. Install the generator control module 3 phase cable clip nut (1).
Tighten the nut to 9 Nm (80 lb in).
24. Enable the high voltage system. Refer to High Voltage Enabling (See: Hybrid Drive Systems/Battery System, Hybrid Drive/Testing and
Inspection/Initial Inspection and Diagnostic Overview/High Voltage Enabling).
25. Install the intake manifold cover. Refer to Upper Intake Manifold Sight Shield Replacement (See: Intake Manifold/Service and Repair/Upper
Intake Manifold Sight Shield Replacement).
