Escalade AWD V8-6.0L Hybrid (2010)
3. Install the spark plug wire to the ignition coil.
4. Inspect the spark plug wire for proper installation:
*
Push sideways on each boot in order the inspect the seating.
*
Reinstall any loose boot.
5. Connect the ignition coil wiring harness electrical connector (1) to the ignition coil.
6. If replacing one of the rear 2 ignitions coils on the right side perform steps 7 through 16, otherwise proceed to step 17.
7. Install the engine bracket (3) to the ignition coil bracket stud and install nut (1).
Tighten the nut to 9 Nm (80 lb in).
8. Raise the vehicle half way.
9. Working through the wheel opening, install the engine bracket bolts (2).
