Escalade AWD V8-6.0L Hybrid (2010)
3. Install the upper control arm retaining bolt to the frame bracket.
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
Note: Do not tighten the nuts unless the suspension is at the curb height position.
4. Install the upper control arm retaining nut and tighten to 160 Nm (118 lb ft).
5. Connect the ESC sensor, if equipped. Refer to Electronic Suspension Rear Position Sensor Replacement - Left Side (See: Sensors and Switches -
Suspension/Ride Height Sensor/Service and Repair/Electronic Suspension Rear Position Sensor Replacement - Left Side) or Electronic
Suspension Rear Position Sensor Replacement - Right Side (See: Sensors and Switches - Suspension/Ride Height Sensor/Service and
Repair/Electronic Suspension Rear Position Sensor Replacement - Right Side).
6. Lower the vehicle.
Rear Axle Lower Control Arm Replacement
Rear Axle Lower Control Arm Replacement
Removal Procedure
1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle (See: Wheels and Tires/Vehicle Lifting/Service and Repair).
2. Support the vehicle at curb height.
3. Remove the lower control arm retaining nuts.
4. Remove the lower control arm retaining bolt.
5. Remove the lower control arm.
Installation Procedure
