Escalade EXT V8-6.0L VIN N (2004)
1. Connect the electrical connector, if equipped
2. Install the upper garnish molding until it snaps into place.
3. Install the plastic push pins (1) to the upper garnish molding.
4. Install the third pillar trim panels.
5. Install the rear window to the vehicle.
Garnish Molding Replacement - Rear Upper (Tahoe/Yukon/Escalade/Suburban)
Garnish Molding Replacement - Rear Upper (Tahoe/Yukon/Escalade/Suburban)
Tools Required
J 38778 Door Trim Pad Clip Remover
Removal Procedure
1. Use the J 38778 in order to remove the rear upper garnish molding.
Insert the J 38778 and work along the front edge of the trim panel from one end to the other.
2. Remove the rear upper garnish molding from the vehicle.
Installation Procedure
Install the roof rear upper garnish molding to the vehicle until it clicks into place.
Garnish Molding Replacement - Windshield Pillar
Garnish Molding Replacement - Windshield Pillar
Removal Procedure