Escalade EXT V8-6.0L VIN N (2004)
Notice: Refer to Fastener Notice in Service Precautions.
1. Install the sight shield retainer and bolts, if required.
Tighten the bolts to 5 Nm (44 inch lbs.).
2. Install the right fuel rail cover.
3. Tighten the right fuel rail cover bolts.
Tighten the bolts to 9 Nm (80 inch lbs.).
4. Install the surge tank/heater hoses to the clip on the right fuel rail cover.
5. Install the left fuel rail cover.
6. Tighten the left fuel rail cover bolts.
Tighten the bolts to 9 Nm (80 inch lbs.).
Notice: Use care when installing the engine sight shield to avoid contacting the (MAP) sensor wire harness connector. Loss of engine performance or
engine damage may result. Manifold Absolute Pressure
7. Install the sight shield to the sight shield retainer.
8. Tighten the intake manifold sight shield bolt.
Tighten the bolt to 10 Nm (89 inch lbs.).