Escalade EXT AWD V8-6.2L (2009)
15. Install the fuel tank filler housing.
16. Install the fuel tank filler housing to fuel tank fill pipe bolts.
Tighten the bolts to 2.3 Nm(20 lb in).
17. Install the fuel tank filler housing to body TORX(R)screws (1) and retainer (2).
Tighten the screws to 2.3 Nm(20 lb in).
18. Refill the fuel tank.
19. Install the fuel fill cap.
20. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection (See: Starting and Charging/Battery/Battery
Cable/Negative/Service and Repair).
21. Use the following procedure in order to inspect for leaks:
1. Turn the ignition ON, with the engine OFF, for 2 seconds.
2. Turn the ignition OFF for 10 seconds.
3. Turn the ignition ON, with the engine OFF.
4. Inspect for fuel leaks.
22. Install the intake manifold sight shield. Refer to Upper Intake Manifold Sight Shield Replacement (See: Engine, Cooling and
Exhaust/Engine/Intake Manifold/Service and Repair).
Evaporative Emission (EVAP) Hoses/Pipes Replacement - 2500 LWB - 98.4L (26 Gal) Tank-Front
Evaporative Emission System Hoses/Pipes Replacement (2500 LWB - 98.4L (26 gal) Tank-Front)
Removal Procedure
Important: Clean all fuel and evaporative emission (EVAP) line connections and surrounding areas prior to disconnecting the lines in order to
avoid possible fuel and/or EVAP system contamination.