Fleetwood V8-350 5.7L DSL VIN N FI (1982)
Fig. 16 Spool valve assembly. Model 605
Fig. 17 Stub shaft removal. Model 605
DISASSEMBLE RACK PISTON, VALVE & WORM ASSEMBLY
1.
Remove valve and worm from rack, then the Teflon ring and O-ring seal from rack piston,
Fig. 14.
2.
Remove snap ring and worm shaft from valve,
Fig. 15.
3.
To disassemble spool valve,
Fig. 16, proceed as follows:
a. Hold valve and tap stub shaft on wooden block to loosen shaft cap.
b. To remove stub shaft, pull cap out 1/4 inch, then disengage pin on shaft from hole in spool,
Fig. 17.
c. Rotate and lift spool from valve body.
d. Remove Teflon rings and O-rings from valve body and spool.
Model 605 Steering Gear Assembly
Fig. 10 Lower thrust bearing & adjuster assembly. Model 605