Fleetwood V8-368 6.0L VIN 9 FI (1982)
a.
Brush 3M 8011 Black Weatherstrip Adhesive or equivalent on both sides of the flange completely around opening.
b.
Apply a bead of 3M 8011 or equivalent into the new weatherstrip carrier (Figure 1). Allow to dry until adhesive becomes tacky
(approximately five minutes).
c.
Install new weatherstrip to flange and allow a minimum of three hours before closing lid.
7.
Close lid and retest for water leaks. If water leaks are found, apply additional 3M 8011 or equivalent under weatherstrip outer lip.
For warranty purposes, use Operation No. T0077 at .6 hour.