Fleetwood V8-368 6.0L VIN 9 FI (1982)
Heater Core: Service and Repair
REMOVAL
1. Remove electrical connections from blower motor, compressor cycling switch, power module and radio lead-in connections. Position wiring
harness out of way.
2. Remove right-hand windshield washer nozzle.
Air Inlet Screen
3. Remove right-hand secondary air inlet screen from plenum.
4. Partially remove rubber molding above plenum (1 screw on right-hand side).
Air Inlet Screen
5. Remove remaining screws and remove primary inlet screen.
6. Remove blower motor.
7. Remove two screws securing compressor cycling switch to module and carefully reposition switch off of module cover.
