Fleetwood V8-368 6.0L VIN 9 FI (1982)
8. Remove 16 screws as shown, holding A/C mode cover and remove cover.
9. Clamp off heater hoses and remove hoses from heater core nipples.
10. Remove one screw and retainer holding heater core to frame at top.
11. With the temperature door in the max. hot position, reach through the temperature housing and push the lower forward corner of the heater core
away from the housing. Then rotate the core parallel to the housing. This causes the core to snap out of the lower clamp. The core may not be
removed in a vertical direction due to the configuration of the lower core tank, lower clamp and temperature housing.
INSTALLATION
1. Remove sealer from surfaces as shown, and install new sealer in positions shown.
2. Position heater core to frame and push core down firmly to seat in clip at bottom.
3. Secure heater core to frame at top with one screw and retainer.
4. Connect heater hoses to heater core nipples and secure with hose clamps.
5. Install A/C module cover and secure with screws as shown.
6. Position compressor-cycling switch to module cover and secure with two screws.
7. Install blower motor.
